ESC & Bullets.

Using the new soldering / torch, i was able to put on all bullets for the ESC & Motor.

One of the tricks i learned about this is, make sure the bare soldered end from the wire that is going into the bullet is a little shorter than the “DEPTH” of the bullet, that way you don’t have any wire sticking out.

Another trick is, when you have the solder in the bullet “CUP PART ” and the solder is in liquid forum, as you put the wire in, go slow but also twist it a little so the wire heats up and the solder on the wire melts with the stuff in the bullet giving you a good connection..